How to build Power Supply 50V 3A stabilized and regulated

Description

Many times we needed a stabilized, together regulated power supply and high relatively output voltage. These specifications him it cover our circuit. It 's a circuit that can give in his exit 40V until 60V 3A, with simultaneous stabilization. The materials that use is very simple and will not exist difficulties in the manufacture, is enough you are careful certain points. 1 ] For output voltages smaller of 50V until 40V, the Q1 is hot enough, so that it needs one big heatsink. 2]For output voltages bigger of 50V up to 70V, the stabilization is not satisfactory. Conclusion: ideal output voltage is 45V until 60V. In the circuit pontesometer RV1, is used in order to we change the output voltage between 40V until 70V, we can however and perhaps it should, him we replace with two constant resistors, when finishe the regulation, in the desirable price. The reason is, that with time is presented change of output voltage, up to 3V, with connected pontesometer. ATTENTION!!! The positive exit correspond in point [ A ] and the exit of 0V in point [ B ], which should not be connected in the ground.
ZY100    HMNR1288D-85I    5960-09    12L2828    VJ1206A272FXBMT    SP54HC82   

Circuit diagram

Part list

• R1=10Kohm
• R2=1 ohm 5W
• R3=3.9 ohms 1W
• R4=6.8Kohm 1W
• R5=390 ohms 1W
• R6=100Kohm 0.5W
• R7=1.2Kohm 1W
• R8=1.8Kohm 0.5W
• R9=3.3Kohm 0.5W
• RV1=470 ohms pot.
• C1-2-4=4700uF 100V
• C3-5=100nF 250V MKT
• Q1=2N3055 on heatsink
• Q2=BD162 or BD243 or BD543
• Q3=BC303 or BC461
• D1....4=Bridge 15A
• D5=LED RED 5mm
• D6-7=10V 1W Zener
• D8-9-10=1N4007
• T1=230Vac / 55V 3A

Reprinted Url Of This Article:
http://www.hqew.net/circuit-diagram/How-to-build-Power-Supply--50V-3A-stabilized-and-regulated_5546.html